One of the coldest, hottest, and most powerful superconductor electric rocket thrusters ever to be tested in space is being built in a hi-tech shed at the bottom of Wainuiomata Hill.
Next stop for the local tech is America, then the International Space Station - then maybe, one day, Mars.
The superconductor magnet and its accompanying thruster is being assembled in Seaview, Lower Hutt. It will be checked in Houston, launched in Florida, and installed on the space station, where it must take its turn to get tested in space for the first time.
"We're going to have [to] turn off during space walks to ensure we don't interfere with the astronauts' equipment if they're in the area," Randy Pollock, the mission's American chief scientist and engineer, says.
"If someone gets close, it could tug on things ... we don't want to pull on the tools or their spacesuits."
But the vagaries of "magnet tug" in the zero gravity of space are eclipsed by the opportunities.
"It has the potential to be a much more flexible system for spacecraft operators."
In the humming Seaview shed, Pollock is supervising the assembly of a superconductor magnet that runs at minus 200 degrees, outside of a core thruster that runs at a blue-hot 1000 degrees. All of it can just about be held in your two hands.
"The group here has a unique knowledge of superconductors," he says.
"We're the only group in the world that is both building our magnets and building our thrusters and operating them, frankly, in the same room.
The superconductor magnet runs at minus 200 degrees. Photo: RNZ / REECE BAKER
"The magnets were built over here behind me, the system for the space station is being assembled there, and in the back of the room is the test facility for our thruster."
The thruster tester is a shining stainless steel vacuum tube the size of a car, nicknamed Geraldine - 'Gigantic and Extremely Radical Atmospheric-Lacking Device for Interesting and Novel Experimentation'. ("Engineer humour," someone comments.)
Two years of work on the 'Hēki' experiment has come down to an intense six-to-seven weeks of testing and assembly by three researchers in blue smocks and masks in a clear plastic booth like a quarantine unit, bolting bits together, religiously recording every single step.
Then to Texas, for more tests. Then, to space, for more again.
The aim, eventually, to come up with an electric rocket engine way more efficient than those in use now - which are already sending Nasa spacecraft to the asteroid belt - that with wee squirts of argon (it shoots out of the thruster in tests at 10-20 kilometres per second) could push a rocket to Mars.
Inside the vacuum chamber. Photo: RNZ / REECE BAKER
"If you ran a chemical rocket, you might fire for tens of seconds or even maybe tens of minutes," Pollock says.
"This you will run for weeks or months or years ... so it enables a class of missions that just wouldn't be practical because of the amount of fuel you would normally have to carry."
What sort of missions?
"If you want to move large amounts of cargo to the moon to Mars."
None of this would be taking place in New Zealand if not for Nick Long.
The country's grandfather of superconductors, Long has spent three decades helping crack the puzzle that makes them usable in experiments like Hēki.
"When they were first discovered people thought, 'Oh, this is great, we're gonna have wires, you know, before we know it,'" Professor Long, the director of the Paihau-Robinson Research Institute at Victoria University, says.
"And actually, it turned out to be incredibly difficult."
Randy Pollock and Nick Long. Photo: RNZ / REECE BAKER
Now, though, the crystals for superconductors can be grown into 100-metre lengths and bought off the shelf, to wrap into the dense coils at the heart of the magnets.
Hēki presents a milestone for Long and his team to see the impact in space in a new way - if they can only get past the nerve-wracking countdown to a February launch on a SpaceX rocket from Florida.
"It's your baby you're sending up there and it has to work, right?" Long says.
"You can't go up and fiddle with it.
"I mean, I'm a laboratory experimentalist and I always like to fiddle with things. They never work first time.
"Luckily, we've got people here who know about sending things into space and making sure they'll work up there, when we, you know, can't get in there with a screwdriver."
Randy Pollock is one of those people, and he has already been to Mars, in a sense: A rock sniffer he made for Nasa's jet propulsion lab in California is currently on the front of the Perseverance rover as it seeks signs of ancient life on the red planet.
But unlike the rover that never returns, New Zealand's landmark superconductor thruster will.
"It goes out an airlock and will spend several months operating on the outside of the space station," Pollock says.
"At the end of that time, it actually comes back in and for the first time in my career, I will actually get the hardware back at the end of a mission.
"Usually it's a one-way trip."
